![]() The menu entry information may have a descriptive name. The USB bootloader itself is automatically hidden for obvious reason. Those lines denote Menu Entry sections, and some are deliberately hidden by the bootloader. Within the block, you should be able to see lines with - : 'SOME RANDOM NAME'. If you see an output, you'd need to look at the very last block starting with the last = line and ending with the last = line as you may have duplicate blocks. If it's blank, chances are you didn't press F2 as instructed in the previous section. If nothing shows up, then you may want to manually check the file by running less /Volumes/CLOVER_USB/EFI/CLOVER/misc/preboot.log. sed -n '/ScanLoader/,/AddCustomTool/p' /Volumes/CLOVER_USB/EFI/CLOVER/misc/preboot.log Once you mount the USB, you'd need to find all the detected volumes that you saw in the bootloader in the previous section. This step assumes you're using the same Mac that was used to create the bootloader on the USB as the preboot.log file would be reviewed on it. Once you're done, you can do a hard shut down and then remove the USB. You only need to briefly memorize the first and last couple characters so you can confidently make sure you are referencing to the correct UUID as we'll find it in the preboot.log file later to conveniently copy and paste. You may want to press a few more time just to make sure it's saved.īefore you go ahead shut down the computer, you may want to highlight the volume ( not actually clicking on it as it'd boot to the OS) in the list and then press the SPACEBAR key to reveal the UUID information. Press the F2 key to save the preboot.log to the USB as you would need it for later steps. You would see that you can save the existing preboot.log to the EFI/CLOVER/misc/ directory. Once you reached the Clover Operating Systems Boot Manager home screen, you should be able to view some options. Perhaps, the VirtualBox test may not be a reliable indicator for you, and you can proceed to test it on the actual hardware just to double-check.įirst, you would need to boot the bootloader on your legacy BIOS system. ![]() If it doesn't load, then you may have misconfigured the USB somewhere. You may start the VM, and it should be able to boot the Clover Bootloader. Once you're done, click on " Ok" to apply the change. ![]() While you're still in the VM's Settings, go to the System tab and select the Enable EFI (special OSes only) extended feature. Click on it and it'd show the options to add the file to it. Click on it and you should see a disk icon on the right side. While creating the VM, you can continue with the default selections in the remaining steps.Īfter you're done creating the VM, go to its Settings, modify its Storage. I won't cover how to use VirtualBox here, but if you're familiar with it, then this step should be relatively straightforward.įirst, you'd need to create a new VM with type set to Linux. Please use the search engine to research for solutions if issues persist. Be sure to review both the General and Privacy tabs in Security & Privacy Settings in System Preferences. You may run into isolated issues with VirtualBox on macOS if installing it for the first time due to security restrictions. At the time of this writing, the latest version was used ( 6.1.26 r145957). ![]() Be sure to also install the latest Extension Pack for VirtualBox. In case you're running macOS on Intel architecture and you would like to quickly make sure USB is bootable before making an attempt on your Legacy BIOS system, you can do so using VirtualBox. You are strongly recommended to skip this section if you are doing this for the first time as it's relatively quicker to test the USB directly on the physical machine. It may be convenient for those who would rather not test the USB on the physical machine until proven otherwise, especially if they were having trouble getting the USB to boot the first time.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |